服务热线: 15306575657 18248457755
新闻资讯
NEWS CENTER
  • 交联聚乙烯复合纳米二氧化硅
  • 本站编辑:杭州孚安保温材料有限公司发布日期:2020-02-29 22:17 浏览次数:

交联聚乙烯垫复合纳米二氧化硅保温毡具有极好的压缩回弹性能。

交联聚乙烯垫复合纳米二氧化硅保温毡应平整铺设 , 板缝应相互对齐 , 横平竖直垫 , 可根据需要切割相邻拼缝 宽度应小于 1.0mm。防水胶带宽度不应小于 80mm, 在拼缝两侧宽度大致相等。应对交联聚乙烯垫复合纳米二氧化硅保温毡之间的拼缝和与竖向隔离片之间拼缝处的防水胶带进行检查。平抹挤出胶带里的气泡 , 抹平胶带褶皱。对不密封的拼缝 , 可在外侧再盖防水胶带 , 加强密封。

交联聚乙烯垫复合纳米二氧化硅保温毡隔音减振垫使用方法:,需要将地面清扫干净,做到无突起物,地面平整其次,铺设减振垫,相接处要整齐密封,如边角不齐,需用刀剪切齐,相接的地方可采取搭接或平接的方式连接,平接则必须用胶水将接缝粘牢,接缝处用胶带封严,防止上层混凝土施工时,水泥砂浆渗入减振板下面,造成传声桥再次在4周墙边将隔音垫边缘向上折起,用建筑胶点粘楼板隔音垫于墙面,翻包高度为包括混凝土和面层的总厚度,折起翻包部分接缝也要用胶带粘贴严密较后铺设厚度不小于40mm的C20细石混凝土,混凝土内需配加固钢筋网,楼板隔音减振垫5mm常用,注意钢筋网不得刺破隔音垫,钢筋网保证在混凝土层的中上部铺设厚度不小于40厚的C20细石混凝土,不得用水泥砂浆代替,且C20细石混凝土水含量不宜过大,容易导致开裂选隔音减振板的时候1定要确切根据需求来选择材质,而不是只关注价格,不同的情况下所有的料是不一样的。

2-1Z6191I015.jpg

ion resilience.

The cross-linked polyethylene pad composite nano silicon dioxide insulation felt shall be laid flat, the slab joints shall be aligned with each other, the horizontal and vertical pads shall be flat, and the width of adjacent joints can be cut as required shall be less than 1.0mm. The width of waterproof tape shall not be less than 80mm, and the width on both sides of the joint shall be approximately equal. The joint between the cross-linked polyethylene pad composite nano silicon dioxide insulation felt and the joint with the vertical isolation piece shall be inspected for the waterproof tape. Smooth out the bubbles in the adhesive tape and smooth out the folds of the adhesive tape. For joints that are not sealed, waterproof tape can be covered on the outside to strengthen sealing.